Alternator belt

  • Hi folks My air conditioning compressor is damaged

    I would like to drive without air conditioning for the time being. Not filled at the moment, hence the damage

    What kind of belt do I need without air conditioning compressor?

    The turbo was also available without air conditioning I assume

    Peter :)

    This post has been automatically translated.

  • Hello Peter,

    The air conditioning compressor has a magnetic clutch that disconnects the compressor when the air conditioning is off. You can therefore simply leave the air conditioning compressor in.

    This post has been automatically translated.

  • Hi, in principle the turbo was also available without air conditioning, but then it has a different limo mount and the air conditioner is lower for reasons of center of gravity. The Americans like to modify this in their racing cars, which means that you need a different bracket without an air conditioning compressor. If the compressor is defective but installed, only the solenoid switch must not be closed.

    This post has been automatically translated.

  • Thank you

    It has bearing damage and it knocks quite a lot in between

    So there is no belt on my turbo where I can simply leave out the air conditioning compressor

    Peter :)

    This post has been automatically translated.

  • Hello Peter.

    The belt is tensioned with the compressor. The models without air conditioning have a different console on the engine. The air conditioner sits at the bottom and tensions the belt.

    Greetings

    Claus

    This post has been automatically translated.

  • I have to remove the compressor, it may be missing oil

    So check what's inside. Refill and the knocking is gone, I hope

    Peter :)

    This post has been automatically translated.

  • If you have not switched on the air conditioning, nothing is turning in the compressor. Then it is the bearing in the pulley.

    Greetings

    Claus

    This post has been automatically translated.

  • Well, I'll be busy tomorrow

    I need a suitable puller =O I can press it in :)

    That's the bearing in the disk?

    Peter :)

    This post has been automatically translated.

  • .... with the air conditioning "off" and a functioning magnetic clutch, the compressor should

    should not actually make any noise; ergo magnetic clutch.....imho...

    This post has been automatically translated.

    Porsche 944 S2 Cabrio,

    Baujahr 1990,

    Farbe Sternrubin

    Km 188000 in 10/2018

  • .... with the air conditioning "off" and a functioning magnetic clutch, the compressor should

    should not actually make any noise; ergo magnetic clutch.....imho...

    Will be the bearing of the drive disk with the screwdriver obeyed, and it is close to the disk very loud knocking

    This post has been automatically translated.